Manual Expansor Dsc 5108

I recently built a new house and in the process I installed a DSC 832 security system using a LCD 5500Z keypad. I installed a PC5108 Zone Expander into the system, but the expand appears not to work. I set the jumpers to obtain zones 9 thru 16 on the expander. I entered section 902 to allow the system to sense the expander and then entered section 903 to verify the expander was supervised. All of the previous actions resulted in the correct displays. Hindi to tamil translation book.

I do not get any type of alarm from the expander. With no connections to the zones 9 thru 16, I still obtain a ready LED on the keypad. I have gone thru the installation and programming manuals several time in an effort to find some command I have missed.

Related Manuals for DSC RF5108-433. Receiver DSC RF5132-433 Instruction Manual. Power series (90 pages). Summary of Contents for DSC RF5108-433. Page 1: How To Use This Manual. (e.g., DLS2002). Read your system Installation Manual for more information. The DSC PC5108 is an 8-zone expansion module to allow for up to eight additional sensors and detectors on a hardwired DSC alarm panel. PC5108 is compatible with PC1616, PC1832, and PC1864.

As a side note, zone 2 on the motherboard acts the same way. I can not get it to display an alarm. All other zones operate per their programming instructions. I would appreciate any help with solving these problems so I may use the system at its capactiy.

DSC programming is notoriously obtuse. For the zone 2 issue, does the zone show open if you physically disconnect the wire at the panel terminals. If so, you may simply have a bad contact (especially if it's one of the press fit types, they can be damaged in installation. There are also things as simple as crushed or skinned wires. A final thing is to make sure that any openings on the zone loop in question are wired in series, not in parallel. If they are in parallel, all openings have to be open for the zone to open.